When you see this message in the S&P App, the Wireless Energy Manager battery needs to be recharged.
Recharge the battery by plugging a power source with the USB-C cable provided into the back of the Wireless Energy Manager for a couple of hours.
If there are no sockets nearby, you can try connecting a power bank / portable charger to charge the battery.
After the battery has recharged for a couple of hours, press the pair button on the back of the Wireless Energy Manager. You should see a blue LED come on inside the Wireless Energy Manager.
Once the battery has recharged it should automatically reconnect to your charger.
Pairing the Wireless Energy Manager
If the message in the S&P App does not go away after recharging the battery and pairing the Wireless Energy Manager, you might need to unpair the Wireless Energy Manager from the charger and then pair it again.
- To do this from the S&P App, stand near the charger and connect using bluetooth.
- Open the installation menu using the PIN 880088 and remove the Wireless Energy Manager under Smart Home Devices.
- Hold the Wireless Energy Manager within 10m of the charger.
- Select Smart Home Devices in the installation menu and select Setup followed by Energy Manager Add (under Wireless Devices, not Wired Devices).
- Press the Pair button on the back of the energy manager for 2 seconds.
- Check to see if the blue LED comes on.
- You might need to switch the Wireless Energy Manager off and then on again for it to pair.
- The full instructions for setting up the Wireless Energy Manager are on our website (PDF link).
Failsafe Charge Rating
When the Wireless Energy Manager has disconnected from your charger, the charger will reverted to a failsafe charge rating to avoid overloading your fuse.
This means that your car will charge at a slower rate until the battery has been recharged and the Wireless Energy Manager is reconnected with the charger.
First Generation Wireless Energy Managers
If your Wireless Energy Manager was installed in 2022 and does not have a USB-C port on the back please contact Simpson & Partners if the battery is flat.
